CheckpointWest
Количка0
Процесор, активни спирачки и електроника

PERUN V2 Lightning ETU модул – окабеляване към приклада

Марка
Perun
Арт. №
PERUN023

В наличност48 бр. на склад

60,81 €Цената е с ДДС.
1

  • Доставка: [СРОК]
  • Връщане: [СРОК ЗА ВРЪЩАНЕ]

Описание

Perun V2 Lightning ETU unit with lightning-fast response

Perun V2 Lightning is a modern ETU unit that replaces traditional mechanical contacts in a V2 gearbox and takes your rifle performance to a whole new level. Thanks to optical and magnetic sensors, there is no contact burning or mechanical wear. Trigger response is instant, operation is consistent and the whole system is better protected against short circuits and overheating. The unit supports a wide range of settings, from trigger sensitivity to pre-cocking, active brake and DMR mode. For an even better shooting feel, we recommend adding trigger modules Clicker V2, Clicker V2 PRO or the fast Speeder V2. Installation is intended for Version 2 gearboxes. This version comes with rear wiring and a pre-soldered T-Deans connector, ready for standard Li-Pol and Li-Ion batteries (including LiHV). Installation requires advanced technical skills, if you are unsure, contact one of our partner service centers for assistance.

Key features of Perun V2 Lightning

Contactless sensors

Optical and magnetic detection replaces mechanical contacts and eliminates wear.

Fully programmable modes

SAFE, SEMI, 2–5 round burst, AUTO, binary trigger and DMR mode with adjustable delay.

Trigger sensitivity and accessories support

8 sensitivity levels from ultra-short pull to longer, more controlled trigger feel. Compatible with Clicker V2, Clicker V2 PRO and Speeder V2.

Pre-cocking and active brake

8 levels of pre-cocking and 5 levels of motor braking for precise tuning.

Protection features

Protection against short circuit, overheating, gearbox jam and low voltage alarm for Li-Pol batteries.

Programming guide

Programming process is identical to Perun HYBRID V2 / V3 units.

Compatibility

  • Gearbox: V2 Tokyo Marui standard
  • Fits without modification: APS Silver Edge, A&K, Bolt, Delta Armory, Double Bell, Double Eagle, E&C, Evolution, G&G, G&P, Golden Eagle, ICS, JG, King Arms, KWA Gen 2.0, LCT, Lonex, Mancraft, Retro Arms, S&T, Specna Arms Orion, SA One, SA Aether, SA Core, Tokyo Marui, Ultimate, Valken, VFC and others
  • Minor modification required: CYMA (light sanding in contact area)
  • Not compatible: Classic Army ECS, Ares EFCS, KWA ERG, G&G ETU triggers

Technical specifications

  • Supported voltage: 7 V – 17 V
  • Supported batteries: Li-Pol, Li-Ion
  • Supported motors: Standard brushed and BLDC brushless motors
  • Supported modules: Clicker V2, Clicker V2 PRO, Speeder V2
  • Connector: T-Plug (T-Deans)
  • Programming: Via trigger and fire selector
  • Li-Pol alarm: 3.7 V per cell
  • Diagnostics and protection: Short circuit, gearbox jam, overheating protection, magnetic field detection, LED error indication

Important notes

  • Always disconnect the battery after use, the unit draws small standby current.
  • Do not use batteries above 17 V, permanent damage may occur.
  • After using pre-cocking, release the spring by switching to SEMI and holding the trigger for about 3 seconds.
  • During installation, ensure proper wire routing to prevent damage.
  • Czech manual
  • English manual

Package contents

  • Perun V2 Lightning ETU unit
  • Rear wiring with T-Deans connector (pre-soldered)
  • Installation and user manual

Параметри

Параметри
VariantsV2 Lighting ETU (Rear)
ColorWhite
Body/receiver materialABS / Plastic
Gearbox versionV2
Connector typeT-Dean
MOSFETYES
Processor unitYES
Battery includedNO
02 // Още от сектора

Подобни продукти

Към магазина →