GUARDER високоскоростен Revolution мотор 40,000 RPM – дълъг вал
Спрян от продажба
В момента не може да се поръча.
- Доставка: [СРОК]
- Връщане: [СРОК ЗА ВРЪЩАНЕ]
Описание
GUARDER High Speed Revolution Long-Shaft Motor
GUARDER High Speed Revolution is a long-shaft AEG motor designed for setups where higher rotational speed and RoF are the priority. The long shaft is primarily suitable for V2 gearboxes used in M4 / M16, MP5, G3, SCAR and other structurally compatible AEGs. The motor features powerful magnets, ball bearings, durable carbon brushes and a Type O steel pinion. To make optimal use of its 40,000 rpm speed, we recommend approximately M90–M110 springs; for significantly stronger springs, a High Torque motor is more suitable. In a high-speed setup, the entire drive system is important, not just the motor itself. In practice, we therefore recommend paying attention to correct gear shimming, motor height adjustment, the condition of the pinion and bevel gear, as well as a suitable electronic unit (MOSFET or ETU). Final RoF always also depends on the gear ratio, spring, battery and overall gearbox tuning.
Key Features
High-Speed Design
The motor is designed for high speeds of 40,000 rpm and increased AEG RoF. It is therefore particularly suitable for setups where cycle speed is more important than high torque.
For M90–M110 Springs
It is best suited for low- to medium-strength M90–M110 springs. For significantly stronger springs, we recommend choosing a High Torque motor.
Long Shaft
The Long Type design is intended primarily for V2 gearboxes and is commonly used in M4 / M16, MP5, G3, SCAR and other compatible AEG platforms.
Durable Internal Design
The motor uses powerful magnets, ball bearings and durable carbon brushes to support smooth operation at high speeds.
Type O Steel Pinion
The Type O steel pinion transfers motor power to the bevel gear. During installation, we recommend carefully adjusting the motor height to ensure correct engagement between the two gears.
Technical Specifications
- Type: High-speed motor
- Speed: 40,000 rpm
- Shaft length: long / Long Type
- Application: high-speed AEG setups
- Recommended springs: M90–M110
- Compatibility: M4 / M16 / MP5 / G3 / SCAR and other AEGs using a long-shaft motor
- Bearings: ball bearings
- Pinion material: steel
- Pinion type: O
Package Contents
- 1× GUARDER High Speed Revolution 40,000 RPM motor (long shaft)
Frequently Asked Questions (FAQ)
Which Springs Is the GUARDER High Speed Motor Suitable For?
For this motor, we primarily recommend M90–M110 springs. Stronger springs increase the load on the motor, and for high-power setups a High Torque motor with greater torque is generally more suitable.
Will a High Speed Motor Increase the Gun's RoF?
Its high rotational speed is specifically intended for builds focused on higher RoF. However, the actual RoF cannot be determined by the motor alone – it is affected by the gear ratio, spring, battery, electrical system and mechanical tuning of the gearbox.
Does the Long Version Fit Every V2 Gearbox?
Long-shaft motors are commonly used with V2 gearboxes, but the specific platform must have a compatible motor cage or pistol grip. We therefore recommend comparing the type of the original motor before purchase.
What Is Important When Installing a High Speed Motor?
Correct gear shimming and motor height adjustment are essential. The pinion must engage the bevel gear correctly without excessive noise or play. For high-RoF setups, we also recommend checking the condition of the electrical system and the overall gearbox timing.
Параметри
| Variants | High Speed / Long Type |
|---|---|
| Body/receiver material | Metal |




